The PMA7000 series audio panel not only provides a great set of capabilities, it
also lends itself nicely for upgrading an existing Bendix/King KMA24 audio
panel. The PMA7000B is KMA24 pin compatible, making the cost of the upgrading
less expensive. None of the existing wires going to the KMA24 have to be
disturb, only a new intercom wire harness has to be built, reducing the amount
of installation time.
With our renown 6-place IntelliVox® automatic Voice
Operated Relay (VOX) intercom system, adjusting a squelch circuit is a
thing of the past. And with over 13 years of field experience, find out just how
easy it is to forget you are even using an intercom, it just works! No more
clipping or missed syllables.
The PMA7000B provide 3-com capability with the option
to easily convert Com 3 to a full duplex cellular telephone interface.
also has our pioneered "Split Mode". This allows the pilot to be on
Com 1 while the copilot is on Com 2, freeing up the pilot to work with ATC while
the copilot gets weather information or finds out just where the lowest fuel
cost is on the field while still in the air.
list of capabilities:
automatic VOX system with individually gated microphones
- Place hi-fi stereo intercom with Soft Mute™
- music mute modes: Mute On and Mute Off
Marker Beacon Receiver
telephone input with dedicated On/Off hook switches for unprecedented
mode for dual audio panel capability
hi-fidelity stereo music source inputs
- Isolation modes - Pilot Isolate, All, and Crew
- unswitched inputs
music muting for passengers
special intercom mode with "Alternate Intercom Mode"
(Radio Active Mute) eliminates constant back ground noise from radio static
only knob that is on the panel is a concentric volume control for the
Crew and Passengers intercom volume. The all push button controls of the
PMA7000B allows for easy selection of Coms and other Nav aids.
The PMA7000B has four un-switched and un-muted inputs. This adds flexibility when installed with today's
advanced warning systems, like Skywatch or TAWS.
are the steps it takes to replace a KMA24 with a PMA7000B:
1) remove KMA24 from tray
2) remove the connector from KMA24 tray
4) install PMA7000B tray
5) install connector in PMA7000B tray
install PMA7000B into tray
As far as the audio panel installation is concerned, its done. GO FLY
You will not have any intercom functions until that portion of the install is
That's why there is second connector. This connector must be wired
by your avionics shop that will provide all of the intercom functions, telephone
interface, and music inputs.
The PMA7000B is plug and play with the original
PMA7000M-S, the PMA6000M-S, and the KMA28.
Audio Panel w/6-place stereo IntelliVox® intercom